Bexley's Federation and inter-war homes have some of the oldest switchboards we see. We map every circuit and replace the board with full safety switch protection.
Switchboard Upgrade Bexley: what we typically find
Bexley's Federation and inter-war homes often have old boards and sub-boards from extensions. We assess the whole installation before upgrading.
Every circuit is tested and labelled.
How the job works in Bexley
We confirm how long your upgrade will take when we quote, and finish with a Certificate of Compliance for Electrical Work.
In heritage areas, we'll check before changing anything visible from the street.
On the day, we isolate the supply, remove the old board, fit the new one, reconnect and test every circuit, and restore power. Labelling every circuit makes future work easier.
If testing reveals circuits with deteriorated insulation, we'll explain the results and quote separately for repairs or rewiring.
Bexley's older homes frequently have a meter box on the side wall with an original board behind a timber or composite panel. Some of these older panels may contain asbestos, so we check before work starts and take appropriate precautions.
When the new board goes in, every circuit is protected by a safety switch, which is the single biggest safety improvement for an older home.
If your home is in a heritage conservation area, the new board can usually be fitted in the existing location so nothing visible from the street changes.
Have this ready when you call
- Photos of all boards
- Renovation plans
- Heritage requirements
Does your board need replacing?
- Ceramic fuses with fuse wire
- No safety switch, or only one
- The board is on an old fibre backing panel
- Breakers or fuses go when several air conditioners run
- You're adding a granny flat, solar, a battery or an EV charger
- The board shows scorch marks or makes a buzzing noise
About Bexley
Many Bexley homes still have original fuse boards and wiring that's been extended piece by piece. Switchboard upgrades, partial and full rewires, and extra power points are our core Bexley work. We take care with original ceilings, cornices and joinery when running new cables.
Read more about our full switchboard upgrades service across the St George, or see our Bexley electrician page.
Switchboard Upgrades in Bexley: FAQs
Do I need to replace my sub-board too?
Not always; we'll assess it.
How long will the power be off?
Usually a few hours on the day of the upgrade. We'll give you the expected window in advance.
Can you upgrade the switchboard in my Hurstville unit?
Yes. If the board is inside your unit it's usually straightforward. If it's in a shared meter room, we'll arrange access with building management.